In our daily life, sometimes you will find the faucet is still leaking after screwing. It always drips and cause a lot of waste. Sometimes its noise would cause some problems. In fact, the structure of faucet is simple, you can totally repair it by yourself. Generally speaking, the problem of faucet leaking could be solved by put the part internal axial shim or triangle seals. However, you should turn off the master switch of faucet before you repair.
The leaking of faucet joint is caused by broken sealing adhesive tape. So we should use the wrench to remove the faucet and roll on the new sealing tape again. Firstly, you should screw the faucet and use the wrench to remove the faucet by anti-clockwise.Then put the threaded holes outward and use the printing tape roll back to 5-6 by clockwise on the threaded part. If the faucet is adjusted well, please use the wrench rolling by clockwise. Finally, you should turn on the total switch to ensure the faucet is not leaking.
If the faucet is still leaking after fasten,we should study further.If the water outlet is leaking, you should use the wrench to tie the gland loosen and remove. Replace a new axial shim. If the lower gap of faucet is leaking, you can remove the bolt head and the gland.Then put a new triangle gasket. If the pipe joint is leaking, you can fasten cap nut again or put on a new U gasket.
It may has been occur water leakage situation if the water become small. It should find a professional repair division leading cleaning. But you must replace a new rubber pad if it is broken. Generally speaking, the correct use of the faucet is don’t rotate the faucet too tight. We also advise replace the hot and cold on both sides of the rubber pad regularly.
